Environmentally friendly products, recycling and environmentally friendly machines are highly values at Unika...
There are more reasons for installing process water mixing unit
Eg an easier and smarter control of form flow and temperature, and at the same time expect less energy consumption.
In plastic injection molding, there can be challenges in maintaining a stable mold flow and temperature between the various cavities. At least if one wants to achieve a consistent quality and less waste.
Unika Danmark A / S is involved in the development of a Danish product that can make the injection molding easier and more uniform and at the same time improve the process around cooling and heating of the molds.
We have contributed with constructive development proposals in the process, and think that the result is so good that we are ready to invest in the installation of several mixing units on the molding injection machines. We have chosen the SC-F100 mixing unit because the supplier is Danish and because we are experiencing the following improvements:
- Easy control of temperature on the mold
- No hoses on the floor = safer working environment
- Correct and uniform castings
- Possibility of quick and easy temperature and flow adjustments
In addition, we expect that our investments in the improved processes will contribute to a better energy account with less energy consumption and CO₂ emissions, fewer stops / starts, fewer fault castings, reduced wear of molds. Better use of water for cooling / heating. In connection with our number two mixing loop, we carry out electronic monitoring, which must show the effect of the SC-F100 in relation to disposal, cycle time and energy consumption per. cast item. The survey will start in week 47-2021.